JBL H (8Ohm). Unavailable. Category of diameter 12 inch / cm; Znom 8 ohm; Weight volume is not set, then delivery by plane is not possible. Brand New JBL H 12″ Aftermarket Recone Kit, 8 ohm. Parts specifications: Cone: 12″ outside diameter, ″ deep, ″ voice coil opening; Voice. Subwoofer JBL H. General specifications: diameter 12 inches, maximum power W. Thiele-Small parameters: frequency of self resonance Fs=75 Hz, .
|Published (Last):||15 October 2006|
|PDF File Size:||1.14 Mb|
|ePub File Size:||13.53 Mb|
|Price:||Free* [*Free Regsitration Required]|
Do it as well as you possible can. Extra Tabs by vBulletin Hispano.
That is a factor determined by the enclosure and crossover. I thought the magnet slab was thicker. Ivan Beaver on February 19, I used to do that all the time-and the speakers were very “workable”. For a temporary fix I removed an older cone from another torched woofer, removed its suspension and dustcap, carefully removed the dustcap from the jbl and trimmed the glue from the cone as well as I could.
JBL H 12″ Aftermarket Recone Kit – Speaker Exchange
Basically the K, K, and shared the same magnet structure, including the top plate. The kit is the same cost as a H. Write a poem to a friend, even a lousy poem. JBL, Generally it will be more like the kit you put in it than the original-but will not have the exact same performance. February 19, February 21, But it has been a few years. Ie putting a kit in an E and so forth.
JBL 2022H 12″ Woofer Speaker Driver 8 Ohm
It has been quite a few years since I was doing reconing-but I remember that the magnet thickness was different between them. Thanks to everyone, good info all around. All times are GMT I’ll leave the flame suit on for this The letter suffix represents the impedance, not frequency range of the speaker. Differences were achieved in cone composition, coil windings, and VC former material.
I guess you would call it JBL’s “midline” series driver. Logged Brian Elstro Jr.
The Marketplace for Musicians |
Please login or register. Last edited by maxwedge; at Is it worth while to recone?
I’ve been thinking of replacing my ‘s with ‘s down the road a bit and if ‘s can be reconed as ‘s then that could be an option Do what Tim recommended and give Charlie Tappa a call. None were specifically for “mid range”.
Ditto E, E, and The rip went all the way around the dust cap which made me think that I had totally blown itand at one point into the middle of the cone.
I’m not aware of it ever being used in a 3-way app as a mid driver. Results 1 to 5 of 5. I think they both fall inbetween the “producer” and “reproducer” sound One starting point in my confusion I read that someone re-coned a to aincreasing x-maxx how This yields an Xmax of only 0.
The time now is Another question, can the be reconed to the specs better LF handling? There was a ridge left behind from the old dustcap glue so I had to score the new cone near the former to get it to lay down flat, but once all the pre-fit was done, glue-ing it in wasnt too big of an issue rubber cement In most cases-similar older JBLS can be reconed “kinda” as different model. It’s really a mid-range, a mid-bass at best. February 24, However the magnet structures and magnetic energy focusing are different-so you will end up some sort of “half breed”.
Suprisingly enough it didnt sound too bad last night, but a real re-cone kit is in order. Logged “can you make them sing better?